Setup
4-17
Part 1123087_02
3/2014 Nordson Corporation
4.. Touch Adhesive Savings, Beads per Pattern, or Bead Pattern and
use the keypad to enter the desired values. Refer to Table 4‐4 for an
explanation of these parameters and their default and optional settings.
NOTE: The EcoBead Settings screen shows an example of the bead
pattern that reflects the Adhesive Savings and Bead Pattern selections.
To see an example of the bead patterns for the amount of Adhesive
Savings selected, touch Help.
5.. Touch Done.
6.. Repeat steps 1.-5. for each applicator zone, adjusting settings as
needed, until the desired adhesive savings and bead pattern are
achieved.
Basic Settings
EcoBead Settings
Zone 1B
Follow Mode
Adhesive Savings:
Bead Pattern:
Beads per Pattern:
30
2
1
Help
Done
Cancel
Example of current
bead pattern
based on Adhesive
Savings and Bead
Pattern selections
Done
0
1
2
3
4
5
6
7
8
EcoBead patterns for the 30% adhesive savings selection.
Patterns for other adhesive savings selections will appear
slightly different.
9
Figure 4‐8 EcoBead Settings screen and EcoBead help screen
To Next Page
Loading...
