Nordson freedom - Initial System Startup (contd)

Setup
4-63
Part 1123087_02
 3/2014 Nordson Corporation
3.. Make sure the Heater Control is On. Touch Master Controls > Heater
Control and observe the Heater Control button to determine the On/Off
status of the heaters.
4.. Touch Master Controls > Refill to disable the fill system.
Grid
175C
Manifold
175C
Zone 1B
175C
Zone 2B
175C
Zone 3B
175C
Zone 4B
175C
Zone 1A
175C
Zone 2A
175C
Zone 3A
175C
Zone 4A
175C
Master
Controls
Pump: On
Heaters: On
Password: Disabled
Recipes:
Nothing Loaded
Fill Status
Pump
Ready
System Status:
Ready/OK
Ready
Done
Scheduler
Pump Control
Heater Control
Standby
Settings System
Scheduler: Off
Pump: OnHeaters: On
Standby: Off
Refill
Enabled
Master Controls
Ready
Figure 4‐32 Accessing the Master Controls screen
5.. Wait until the System Status indication shows Ready/OK.
Pump: Off
Heaters: On
Password: Disabled
Recipes:
Nothing Loaded
System Status:
Ready/OK
System Status
indication
Figure 4‐33 Location of the System Status indication on the Home screen