Nordson freedom - To flush the melter and test the system

Setup
4-65
Part 1123087_02
 3/2014 Nordson Corporation
To flush the melter and test the system
1.. Add adhesive to the adhesive bin.
2.. Touch Master Controls > Refill to enable the fill system.
Grid
175C
Manifold
175C
Zone 1B
175C
Zone 2B
175C
Zone 3B
175C
Zone 4B
175C
Zone 1A
175C
Zone 2A
175C
Zone 3A
175C
Zone 4A
175C
Master
Controls
Pump: On
Heaters: On
Password: Disabled
Recipes:
Nothing Loaded
Fill Status
Pump
Ready
System Status:
Ready/OK
Ready
Done
Scheduler
Pump Control
Heater Control
Standby
Settings System
Scheduler: On
Pump: OnHeaters: On
Standby: Off
Refill
Enabled
Master Controls
Ready
Figure 4‐35 Enabling the fill system
3.. Wait for the system to fill the melter with adhesive and to reach
Ready/OK status.
NOTE: At initial startup, the system requires more than one cycle to fill.
Although this is normal, a fill warning may be generated. Acknowledge
the warning and reset the system, thus initiating another fill cycle after a
short delay. It can take several fill cycles to satisfy the level sensor. After
the melter is properly filled, the system will work normally to maintain the
proper adhesive level.