Nordson freedom - Calibrating the Level Sensor (contd)

Troubleshooting
7-31
Part 1123087_02
 3/2014 Nordson Corporation
To relieve system pressure
1. From the Home screen, touch Pump > Pump Control to switch Off the
pump.
2. Trigger the applicators until adhesive no longer flows from the
applicators.
3. Set the pump air pressure to zero (0).
4. Shut off the main air supply to the melter.
Grid
175C
Manifold
175C
Zone 1B
175C
Zone 2B
175C
Zone 3B
175C
Zone 4B
175C
Zone 1A
175C
Zone 2A
175C
Zone 3A
175C
Zone 4A
175C
Master
Controls
Pump: On
Heaters: On
Password: Disabled
Recipes:
Nothing Loaded
Fill Status
Pump
Ready
System Status:
Ready/OK
Recipes:
Nothing Loaded
System Status:
Ready/OK
Purge
Auto Pump
OffPump: Off
Done
Pump Control
Pump
Off
Ready
Figure 7‐15 Accessing the Pump Control button