Nordson freedom - To purge the melter

Troubleshooting
7-32
Part 1123087_02
 3/2014 Nordson Corporation
To purge the melter
1. Place a drain pan under the melter manifold and disconnect a hose from
one of the hose ports marked 1.
2. From the Home screen, touch Pump > Purge.
3. Turn the main air supply back on and then slowly increase the pump air
pressure.
4. When adhesive stops flowing from the manifold, touch Purge to stop the
purge.
5. Reconnect the hose and appropriately dispose of the drained adhesive.
Grid
175C
Manifold
175C
Zone 1B
175C
Zone 2B
175C
Zone 3B
175C
Zone 4B
175C
Zone 1A
175C
Zone 2A
175C
Zone 3A
175C
Zone 4A
175C
Master
Controls
Pump: On
Heaters: On
Password: Disabled
Recipes:
Nothing Loaded
Fill Status
Pump
On
System Status:
Ready/OK
Recipes:
Nothing Loaded
System Status:
Ready/OK
Purge
Auto Pump
OffPump: On
Done
Pump Control
Pump
Off
Ready
Figure 7‐16 Accessing the Purge button