Nordson freedom - To make sure the adhesive hopper is empty

Fill Status button indicating that the
fill system is disabled
Disabled
Fill Status
Troubleshooting
7-33
Part 1123087_02
 3/2014 Nordson Corporation
To make sure the adhesive hopper is empty
1. Tilt open the hydraulics assembly as follows:
a.. Verify that the Fill Status button on the Home screen indicates
Disabled.
b.. Remove the hydraulics cover. Refer to Removing or Installing Covers
in Section 6, Maintenance, as needed.
c.. See Figure 7‐17. Pull the spring-loaded pin to release the assembly
and carefully tilt it open.
Figure 7‐17 Location of the spring‐loaded pin used to tilt open the hydraulics assembly