Nordson freedom - Melter circuit boards

Repair
8-19
Part 1123087_02
 3/2014 Nordson Corporation
1
7
2
4
5
3
6
9
8
See Detail A
Detail A
10
Figure 8‐11 Melter circuit boards
1. Power module board
2. Main board
3. Fill board
4. Hose interface board
5. Expansion board
6. EcoBead board
7. Power supply board
8. Touchscreen assembly
9. Customer SD card
10. Correct installation orientation
for the EcoBead board
Note: Make sure the EcoBead board is installed in the orientation shown in this illustration.
Note: See Figure 7‐31 for an alternate illustration of the board locations.
Note: The CPU/LCD board on the touchscreen assembly is replaced by replacing the entire touchscreen assembly. Refer
to Replacing the Touchscreen Assembly later in this section.