Installation
3-9
Part 1123087_02
3/2014 Nordson Corporation
WARNING! Risk of personal injury or equipment damage. Installation of the
melter requires two people.
4. See Figure 3‐7. With one person on each side of the melter, make sure
each person grasps each handle with one hand.
5. Lift the melter vertically off the shipping pallet and position it on the
mounting bracket.
6. Using the M5 bottom support knob from the ship‐with kit, fasten the
melter bottom bracket to the mounting surface.
Figure 3-7 Installing the melter on the mounting bracket
To Next Page
Loading...
