Typical voltage plugs
(plugs with and without the neutral
lead shown)
Installation
3-22
Part 1123087_02
3/2014 Nordson Corporation
Configure the Electrical Service (contd)
6. Refer to Table 3‐2 to determine the part number of the voltage plug that
matches the required electrical service. Each voltage plug is labeled with
its part number and service type.
See Figure 3‐17.
7. Insert the correct voltage plug into terminal block X1 on the expansion
board. Make sure the plug snaps into place. If the plug contains a neutral
lead, connect the neutral lead to terminal block X2.
8. When the electrical service is completely installed and inspected in
accordance with local electrical codes and standards, close the electrical
enclosure door and switch the local power disconnect switch on.
If the electrical service was configured correctly, the melter touchscreen
indicates “System Status: Off” when power is supplied to the melter.
To Next Page
Loading...
