Nordson freedom - To connect hoses

Installation
3-40
Part 1123087_02
 3/2014 Nordson Corporation
To connect hoses
Observe the following guidelines:
 Use hose fittings to connect hoses to the manifold. Straight fittings
(P/N972628) are supplied in the ship‐with kit. The following hose fittings
are also available: 45‐degree (P/N 972647) and 90‐degree (P/N 972646).
To use a 45‐degree or 90‐degree hose fitting, remove the applicable
manifold guard and then install and tighten the hose fitting. Reinstall the
manifold guard before connecting the hose.
NOTE: Straight fittings can be installed without removing a manifold
guard. Figure3‐27 shows two views of the bottom of the melter, one with
the manifold guards installed (1) and one with the manifold guards
removed (2).
 To prevent stagnant adhesive from degrading in the manifold, connect
the first hose to either of the hose ports marked 1, as shown in
Figure3‐27. Connect other hoses to any other hose ports on the
manifold.
NOTE: The hose port number is obscured by the manifold guards.
Figure3‐27 shows two views of the bottom of the melter, one with the
manifold guards installed (1) and one with the manifold guards
removed(2).
 See Figure 3‐28. Make sure the hose solenoid valve cable is properly
connected to the applicator solenoid valve.
 Refer to the user's guide provided with each Nordson hose. The guide
contains important information about routing and installing the hose.
 Save all of the plugs that were removed from the hose ports. A plug will
need to be reinstalled into a hose port if a hose is later removed.