Installation
3-42
Part 1123087_02
3/2014 Nordson Corporation
To connect applicators
Observe the following guidelines:
Refer to Appendix A, Calculating Melter Power Requirements, for
information about how to calculate the power required by Nordson
applicators.
See Figure 3‐28. Make sure the applicator cordset is properly connected
to the hose cordset.
Refer to the user's guide that is shipped with each applicator for
information about installing the applicator and connecting a hose to the
applicator.
5
4
2
6
3
1
Figure 3‐28 Hose to applicator cordset and cable connections
1. Solenoid valve
2. Hose‐to‐solenoid‐valve cable
3. Applicator
4. Applicator cordset
5. Hose cordset
6. Hose
To Next Page
Loading...
