I-4 Index
SECS/GEM ..................................................................... 1-10
Sensor
board adjustment .................................................... 5-15
Service Shutdown ......................................................... 2-16
Service Station ..................................................... 1-10, 1-16
height adjustment ...................................................... 5-7
setup .......................................................................... 3-8
Shutdown ...................................................................... 4-51
service ...................................................................... 2-16
Single-Axis Automatic Tilt ............................................. 1-10
SMEMA
interface problems ..................................................... 7-7
Specifications
stability analysis ......................................................... 9-8
system dimensions .............................................. 9-4–9-7
Startup ............................................................................
4-2
T
Tactile Sensor
troubleshooting ....................................................... 7-12
Tensioning
cables ....................................................................... 6-17
conveyor belts .......................................................... 6-25
Testing
impingement flowmeters......................................... 5-29
Training
student certification ................................................... 1-2
Troubleshooting
conveyor .................................................................... 7-7
dispensing head ......................................................... 7-5
Fluidmove startup ...................................................... 7-3
laser height sensor ..................................................... 7-6
mechanical/tactile height sensor ............................... 7-6
needle heater ........................................................... 7-12
pneumatic .................................................................. 7-4
record keeping ........................................................... 7-1
scale ......................................................................... 7-10
substrate heaters........................................................ 7-8
system accuracy ......................................................... 7-3
system power ............................................................. 7-2
tactile sensor ............................................................ 7-12
vision system .............................................................. 7-9
U
Uncrating and Placing the Dispensing System ................. 3-2
Unpacking Replacement Parts ........................................ 8-2
V
Vacuum Control
adjustment ............................................................... 4-10
Valve .................................................... See Dispensing Valve
Valve Offsets ........................................................ 4-21, 4-28
Ventilation Exhaust System ........................................... 1-10
Vision System .................................... 1-11, See also Camera
lighting adjustment................................................... 4-19
Monocle
.................................................................... 1-11
standard ................................................................... 1-11
troubleshooting .......................................................... 7-9
W
Water Trap
draining....................................................................... 6-7
Weigh Station ........................................................ See Scale
Workpiece Alignment .................................................... 4-27
Z
Z height
safe ........................................................................... 4-25
Z-head Counterbalance Force Adjustment .................... 5-11