2-12 Safety
2.9 Residual Safety Risks
Safety Hazard Risk Area
A high risk crushing hazard is created by the
movement of the conveyor. DO NOT reach into the
conveyor while the system is operating. Keep
hands away from this area unless the system power
is off.
A high risk burn hazard is created by the heaters.
Keep hands away from this area unless the system
power is off and heaters have cooled.
If the system is equipped with a Class 2 laser height
sensor, serious eye injury may occur by staring
directly into the laser beam on the laser height
sensor. The laser height sensor is located behind
the camera and not visible from the front of the
machine. DO NOT bypass the safety interlock. DO
NOT open the hatch while the laser is on. Wear
protective goggles when using the laser height
sensor. See 2.10 Laser Radiation.
A hand entanglement hazard is created by the
movement of the drive cables and motor pulley.
DO NOT remove the access panels while the
system is operating. DO NOT bypass the safety
interlock. DO NOT operate the equipment with the
access panels removed and/or doors open. Keep
hands away from this area unless the system power
is off.
Figure 2-8 S2-900 Safety Hazard Areas
To Next Page
Loading...
Need help?
General