Safety 2-17
6. Install an approved lockout clamp and keyed lock onto the pneumatic fitting so it cannot be
reconnected to the main air regulator, and attach an approved tag. Ensure the owner, date,
reason, and estimated time to repair are clearly marked on the tag.
NOTE Warning tags document the name of the technician taking the equipment out of operation,
the date, and other facility-required information. It is a warning that the equipment cannot
be put back into operation until the authorized technician has removed the tag.
WARNING! If your dispensing system is equipped with a heater, allow sufficient time for the
heater to cool prior to performing maintenance or service. Failure to do so may
result in serious burn injury.
Figure 2-13 Electrical/Pneumatical Lockout/Tagout
To Next Page
Loading...
