Nordson Spectrum II Series User Manual

2-6 Safety
2.8 Safety Warning Labels
Safety warning labels on the S2-900 Series Dispensing System point out potentially hazardous areas and
remind personnel to take necessary safety precautions. Table 2-1 describes safety warning labels that may
be on the dispensing system.
WARNING! Comply with all safety warning labels or serious injury to personnel or damage to
the dispensing system may occur. Worn or damaged labels should be replaced
with new labels having the same part number.
 NOTES Triangular labels with symbols only are placed on machines that are shipped to the
European community, referred to as “CE labeled” machines.
Rectangular labels with symbols and text are placed on machines that are shipped
outside the European community.
Table 2-1 Safety Warning Labels
Warning Type
Label/
Symbol
Part
Number
Hazard
Clean Dry Air
Required
7241298
Warns that the water traps must be connected
to clean dry air.
Consult
Operator’s
Manual
7219555
Warns personnel to read the Operator’s
Manual before operating the machine.
7206854
Electrical
(Shock Hazard)
70-0116-00
Warns personnel of a high-voltage component
that can cause shock, burn, or death.
Use extreme caution when working in or
around these areas.
Disconnect and lock out power
before servicing.
70-0050-00
Emergency
Machine Off
Symbol
---
This symbol is located on the Emergency
Machine Off Buttons located on the front and
back of the dispensing system.
General
Warning
70-0055-00
This label identifies a component that requires
special attention. May cause serious bodily
harm to the user.
Disconnect and lock out power
before servicing.
Hand
Entanglement/
Moving Material
7214364
Warns of moving parts that can cause serious
injury to hands and fingers.
Disconnect and lock out power
before servicing.

Nordson Spectrum II Series Specifications

General

Brand	Nordson
Model	Spectrum II Series
Category	Dispenser
Language	English