Proceed as follows:
Unlock the hoisting lift and push
the hoisting lift mandrel careful-
ly into the notch below the devel-
oper station to the stop point.
If the hoisting lift mandrel does
not slide easily into the notch,
correct the height and/or align-
ment of the hoisting lift.
3.
Lock the hoisting lift and check
that it is properly secured by
pulling the replacement cart.
4.
Caution
Insert the developer station carefully
To prevent damage, slide the developer station carefully and evenly into the
print module up to the stop point.
Pull the locking bolt and push
the developer station carefully
and evenly into the print module
up to the stop point.
5.
Chapter 6 - Operating the Printing System 191
Installing the developer station
To Next Page
Loading...
