Proceed as follows:
Put the funnel onto the develop-
er bottle, fit the seal onto the in-
sert and press down.
5.
Snap the hose onto the filler cap
of the developer station and hang
the developer bottle upside down
on the support.
Adjust the height of the support
so that there is no bend in the
hose.
6.
Remove the sealing clamp from
the hose.
7.
Click the 'OK' button to start the filling process.
The blower is switched on automatically. The developer runs into the developer
station without being shaken. After approx. four minutes, the filling process
is completed; the blower continues to run.
8.
Chapter 8 - Replacing Consumables342
Fill in Developer
To Next Page
