Proceed as follows:
Swivel up blower unit by the
handle.
7.
Caution
Do not damage the discharge brush
Ensure that you do not bend the discharge brush.
Remove the upper discharge
brush.
To do this, carefully pull the
discharge brush out of the clamp
springs on both sides.
8.
Caution
If the smoothing rollers have not cooled down yet, you may sustain burns if
you touch them.
Put on heat protection gloves to continue working.
Caution
Do not damage the smoothing roller
Ensure that you do not damage the smoothing rollers on the edges of the
blower unit.
Chapter 9 - Replacing Expendables 457
Removing the smoothing rollers
To Next Page
Loading...
