PREVOST LE MIRAGE XLII BUS SHELLS User Manual

Section 26: XLII SLIDE-OUT
PA1553
36
16.11.3 Slide-out bottom
Apply Sika 221 between bottom edge of side
panel and structural member
FIGURE 82
Apply Sika 221 between edge of bottom panel
and structural member
FIGURE 83
Apply Sika 221 between the bottom panel and
the magnets
FIGURE 84
Apply Sika 221 around the security pin cavity
FIGURE 85
16.11.4 Top of Slide-out
Apply Sika 221 between edge of top panel and
structural member
FIGURE 86
17 WELDING PRECAUTION
CAUTION
Prior to arc welding on the vehicle, refer to the
Welding Precautions Procedure Prior To
Welding" in section 00 GENERAL of this
manual to avoid serious damage to the
vehicle components.
18 SLIDE-OUT MANUAL
OVERRIDE PROCEDURES
In case of power retracting system failure, it is
possible to use the manual override procedure
to retract or extend the slide-out.

PREVOST LE MIRAGE XLII BUS SHELLS Specifications

General

Brand	PREVOST
Model	LE MIRAGE XLII BUS SHELLS
Category	Buses
Language	English