PROCEDURE NO: PR060034 REVISION 3
Page 12 of 15
SECTION 3 XLII MTH
2.00
Location: Dashboard
Place the ignition switch to the OFF position.
2.05
Location: Engine compartment R. H. side area
Trip circuit breakers CB1-CB2 located on circuit breaker
panel.
Push the blue button in to open the
circuit
2.10
Location: Rear Junction Box
Disconnect the electronic ground terminals from this stud.
Warning: The remaining terminals may still be
energized.
Use electric tape; make sure that cables do not touch each
others and the vehicle body.
NOTE
With disconnection of the electronic ground terminals,
disconnecting the engine ECM, transmission TCM and
the dashboard electronic components (telltale module,
HVAC module, radio, control head, …) is not required.
To Next Page
Loading...
Need help?
General
