Quantum Scalar i500 User Manual

Chapter 3 Configuring Your Library
Working With User Accounts
Scalar i500 User’s Guide 100
The library supports all LDAP servers. You can also use Kerberos for
added security. For specific instructions on configuring Kerberos, see
Configuring Kerberos
on page 104.
The
Login screen displays remote authentication login options only when
LDAP is enabled.
LDAP Server Guidelines
3
The following groups must be created on the LDAP server to enable
remote login on the library:
• Library user group — Assign users to this group who need user-
privilege access to the library. Enter the name of this group in the
Library User Group field on the Setup - Remote Authentication screen
on the library Web client (see Configuring LDAP on the Library
on
page 101).
• Partition groups — For LDAP users with user privileges, access to
library partitions is determined by group assignment on the LDAP
server.
Groups must be created on the LDAP server with names that
match the library partition names (names must match but are not
case sensitive). Users with user privileges must be assigned to these
groups on the LDAP server to have access to the corresponding
partitions on the library.
• Library admin group — Assign users to this group who need
administrator-privilege access to the library. LDAP users with
administrator privileges have access to all partitions and
administrator functions and do not need to be assigned to partition-
related groups on the LDAP server. Enter the name of this group in
the
Library Admin Group field on the Setup - Remote Authentication
screen on the library Web client (see Configuring LDAP on the
Library on page 101).
You will need to have at least one user assigned to both the Library User
Group and the Library Admin Group on the LDAP server in order to test
the LDAP settings on the library (see Testing LDAP Settings
on page 103).
Since most normal users will not be members of both these groups, you
may need to create a special or temporary user specifically for this
purpose.

Quantum Scalar i500 Specifications

General

Form Factor	Rack-mountable
Product Type	Tape Library
Weight	Varies by configuration
Power Consumption	Varies by configuration
Drive Support	LTO-8, LTO-7, LTO-6
Management	Web-based remote management
Drive Type	LTO Ultrium
Supported Media	LTO-5, LTO-6, LTO-7, LTO-8
Operating Temperature	10°C to 35°C
Humidity	20% to 80% (non-condensing)
Interface	SAS