Chapter 10 Getting Information – Logs and Reports
Viewing the Network Settings Report
Scalar i500 User’s Guide 275
Viewing the Network Settings Report
The Network Setings Report provides information on the following
library network settings:
•
Network — host name, primary DNS, alternate DNS.
•
IPv4 Settings — Dynamic Host Configuration Protocol (DHCP)
enabled/disabled, IP address, gateway address, and net mask.
•
IPv6 Settings (if IPv6 is enabled) — DHCP enabled/disabled,
Stateless enabled/disabled, Static enabled/disabled, network prefix,
gateway, and all IPv6 addresses.
•
SSL — SSL, port, and cipher of the library.
•
SMI-S — access and state enabled/disabled settings of the library.
•
Access: Indicates whether the SMI-S port for SMI-S traffic to the
library (port 5988) is enabled or disabled. You can change the
setting via the operator panel,
Tools > Security menu. The default
setting is enabled.
•
State: Indicates whether allowing SMI-S to run on the library is
enabled or disabled. You can change this setting on the operator
panel,
Tools > System Settings. The default is disabled.
•
SNMP — access enabled/disabled, V1 enabled/disabled, V2
enabled/disabled, V3 enabled/disabled, algorithm, encryption
enabled/disabled, and port.
•
SNMP-Traps — IP addresses and ports.
The path to open the report from the Web client is
Reports > Network
Settings
.
To Next Page
Loading...
Need help?
General