Chapter 3 Configuring Your Library
Managing the Network
Scalar i500 User’s Guide 62
The paths to open the appropriate screens are as follows:
• From the Web client, select
Setup > Network Management > Network.
• From the operator panel, select
Setup > Network Mgmt.
Enabling SSL 3
Administrators can enable or disable SSL settings on the library. Enabling
SSL settings encrypts all Web browser connections to the Web client, and
it enables SSL-based authentication for SMI-S. SMI-S is the newest
standard of SNMP, which makes sets of data continuously available.
SMI-S is disabled by default. You can enable SMI-S on the
Tools > System
Settings
screen on the operator panel.
The default SSL setting is
Disabled. Disabling SSL settings creates an
unencrypted connection from a Web browser to the Web client.
See the Scalar Intelligent Libraries SMI-S Reference Guide (6-01317-xx) for
further configuration and access details.
Caution: Modifying network settings will modify network
connectivity parameters, requiring remote communication
configuration changes. Your current Web client browser
session might become invalid, requiring you to close your
current browser session. Access the Web client using the
new network configuration settings and log in again.
Note: Be sure to add your library’s IP address to the list of
trusted/allowed sites on your library-supported browser, so
the Web client pages automatically refresh.
Note: For step-by-step network configuration instructions, see your
library’s online Help. To access the online Help system, click
the
Help icon at the top right of the Web client or operator
panel user interface.
To Next Page
Loading...
Need help?
General