Quantum Scalar i500

Chapter 12 Installing, Removing, and Replacing
Adding Expansion Modules to an Existing Library
Scalar i500 User’s Guide 359
9 Repeat these steps for each module you need to re-install in the
library configuration.
Preparing to Use the
Library 12
Prepare to use the library as follows:
1 Add the tape drives to the modules. For details, see Adding,
Removing, and Replacing Tape Drives on page 444.
2 Add the power supplies. For details, see Adding, Removing, and
Replacing Power Supplies on page 420.
3 Add the LCB to the control module. For details, see Removing and
Replacing the Library Control Blade and LCB Compact Flash Card on
page 408.
1 Y-rail in unlocked, functional
position