Chapter 4 Advanced Reporting
Working With Advanced Reporting Reports
Scalar i500 User’s Guide 138
• Grouping — Specifies which tape drive(s) or partition(s) to include in
the report. Select one of the following:
• All Drives by Coordinate (default) — Presents the sum total of
the selected Attribute for all tape drives according to their
location in the library. If more than one tape drive resided in that
location during the selected Date Range, then the Attribute
values for all the tape drives that resided in that location are
combined in the chart.
• All Drives by Physical SN — Presents the sum total of the
selected attribute for all drives according to the physical tape
drive serial number.
• All Partitions — Presents a comparison of all drives grouped by
partition in the physical library.
• Selected Drive by Coordinate — The report chart is based on an
individual tape drive location in the library. If more than one
tape drive resided in that location during the selected Date
Range, then the attribute values for all the tape drives that
resided in that location are combined in the chart.
• Selected Drive by Physical SN — The report chart is based on an
individual tape drive identified by its physical drive serial
number.
• Selected Partition — The report chart is based on an individual
partition in the physical library.
You can only access this report from the Web client. The path to open the
report is
Reports > Advanced Reporting > Drive Resource Utilization.
Configuring the Media
Integrity Analysis Report4
This report provides TapeAlert counts for various combinations of tape
drives, tape cartridges, and TapeAlert flags. You can use this report to
help determine if a problem is due to a specific tape drive or tape
cartridge.
The report displays the number of TapeAlerts for the selected Grouping
and combination of Attributes. Additionally, the downloaded report
includes the last 10 tape drive error codes for each TapeAlert, displayed
in columns with the headings
Error #1, Error #2, and so on. (The onscreen
report does not contain the tape drive error codes.)
To Next Page
Loading...
Need help?
General
