Chapter 3 Configuring Your Library
Setting the Date, Time, and Time Zone
Scalar i500 User’s Guide 106
6 At the command prompt, create the keytab file for the SPN. Use one
of the following formats:
• For Windows 2003:
ktpass -out library.keytab -princ
library/<fqdn of library>@<realm>
+rndPass -ptype KRB5_NT_SRV_HST -crypto RC4-HMAC-NT -
mapUser <realm>/computers/<computer account>
For example:
ktpass -out library.keytab -princ
library/delos.dvt.mycompany.com@OURREALM.LOCAL
+rndPass -ptype KRB5_NT_SRV_HST -crypto RC4-HMAC-NT -
mapUser ourrealm.local/computers/kerbtest
• For Windows 2008:
ktpass -out library.keytab -princ library/
<fqdn of library>@<realm>
+rndPass -ptype KRB5_NT_SRV_HST -crypto AES256-SHA1
-mapUser <realm>/computers/<computer account>
For example:
ktpass -out library.keytab -princ
library/delos.dvt.mycompany.com@OURREALM.LOCAL
+rndPass -ptype KRB5_NT_SRV_HST -crypto AES256-SHA1
-mapUser ourrealm.local/computers/kerbtest
Setting the Date, Time, and Time Zone
Administrators can either set the library date, time, and time zone
settings manually or configure the Network Time Protocol (NTP).
Note: The following operations should not be performed
concurrently by multiple administrators logged in from
different locations. You can access the appropriate screens, but
you cannot apply changes while another administrator is
performing the same operation.
To Next Page
Loading...
Need help?
General