Chapter 3 Configuring Your Library
Using the Setup Wizard
Scalar i500 User’s Guide 55
given for each task. For the operator panel, the paths refer to the
navigation tabs at the top of the home page. For the Web client, the paths
refer to the menus.
For the menu trees on both the operator panel and Web client, see Menu
Trees on page 45.
Using the Setup Wizard
The Setup Wizard simplifies the process of configuring the library. When
you first power on the library, the operator panel displays the Setup
Wizard. After that, you can no longer access the Setup Wizard from the
operator panel. You can always access the Setup Wizard from the
Setup
menu on the Web client.
The recommended procedure for using the Setup Wizard for the initial
configuration is as follows:
1 Turn on the library and begin using the Setup Wizard on the operator
panel.
2 Work through all of the screens as prompted (see Setup Wizard Tasks
on page 57).
3 When you get to the network configuration screens, configure the
network settings as follows:
• If you are using IPv4: On the Setup Wizard: Enable IPv6 screen, do
NOT select the
Enable IPv6 check box. Click Next. Configure the
network settings.
Note: Power cycling (powering the library on and off) is not
necessary to configure the library.
Note: You cannot log into the Web client until you have
configured the network settings.
To Next Page
Loading...
Need help?
General