Chapter 3 Configuring Your Library
Working With User Accounts
Scalar i500 User’s Guide 103
page 50 for information on privilege levels). This group must exist on
your LDAP server (see LDAP Server Guidelines
on page 100). For an
example, see Figure15
.
Figure 15 LDAP Setup
Example
Testing LDAP Settings 3
The Test Settings button tests communication between the library and the
LDAP server, and tests the currently applied LDAP settings. If there are
any problems, an error message identifies the problem area.
If you change the LDAP settings, click
Apply to save your changes before
testing them. Otherwise, any changes you made will be lost and will not
be tested.
To test the settings, you must type a user name and password, then click
the
Test Settings button. The user you use for the test must be a member of
The simple LDAP server
configuration shown below would
give the library settings shown at
right.
Simple LDAP Server Configuration:
To Next Page
Loading...
Need help?
General