Chapter 4 Advanced Reporting
Working With Advanced Reporting Reports
Scalar i500 User’s Guide 139
The Media Integrity Analysis report collects the following information for
each TapeAlert:
• Date and time (UTC) of TapeAlert occurrences
• Tape drive physical serial number
• Cartridge barcode
• TapeAlert value
• Occurrence count of each TapeAlert
• Tape drive error codes for each TapeAlert
To configure the report, specify the following:
•
Date Range — Specifies the range of time covered in the report.
Choose one of the following:
• Last 7 days
• Last 4 weeks (default)
• Last 3 months
• All History (as far back as there is data in the log file)
•
Attribute—Specifies which values are included in the report, and how
they are combined. Select in any combination, including all (default).
If you select no attributes, the report uses Cartridge Barcode.
• Cartridge Barcode — All relevant tape cartridges.
• Drive Physical SN — All relevant tape drives.
• TapeAlert — All TapeAlert flags that were issued. For a
description of all TapeAlert flags, see Appendix B,
TapeAlert
Flag Descriptions.
•
Chart — Specifies how the data is displayed in the chart. Choose
Area, Bar (default), Line, or Pie.
•
Type — Specifies the chart type. Select one of the following:
• Rollup (default) — Displays the number of TapeAlerts for the
combination of Grouping and Attributes you selected (default).
• Trend — Shows the occurrence of TapeAlerts over time.
To Next Page
Loading...
Need help?
General
