Scalar i500 User’s Guide xii
Saving the Library Configuration ........................................................ 495
Restoring the Library Configuration and Library Firmware ........... 495
Troubleshooting “Library Not Ready” Messages..................................... 496
Duplicate Devices Discovered ..................................................................... 497
Duplicate Media Changer Devices Discovered......................................... 498
Identifying Tape Drives ................................................................................ 498
Retrieving Tape Drive Logs.......................................................................... 501
Retrieving Tape Drive Sled Logs................................................................. 502
Identifying FC I/O Blades............................................................................ 502
Permanently Removing FC I/O Blades...................................................... 503
Resetting FC I/O Blade Ports....................................................................... 504
Viewing and E-Mailing the Command History Logs............................... 505
Interpreting LEDs .......................................................................................... 506
Blade Status LEDs................................................................................... 506
Blade Port LEDs ...................................................................................... 509
Servicing the LCB Based on LED Status.............................................. 511
Tape Drive LEDs..................................................................................... 511
Tape Drive Fibre Port Link LED........................................................... 513
Power Supply LEDs ............................................................................... 514
Using the Installation Verification Test ...................................................... 515
Viewing the IVT Logs ............................................................................ 517
Saving and E-mailing the IVT Logs ..................................................... 517
Running Library Demo.......................................................................... 518
Configuring the Internal Network .............................................................. 519
Library Diagnostics........................................................................................ 519
Drive Diagnostics........................................................................................... 520
Drive Tests ............................................................................................... 520
Media Tests.............................................................................................. 521
Ethernet Expansion Blade Control....................................................... 522
Robotics Diagnostics...................................................................................... 523
Chapter 14 Working With Cartridges and Barcodes 524
Handling Cartridges Properly ..................................................................... 525
Write-Protecting Cartridges ......................................................................... 526
Barcode Label Requirements........................................................................ 526
Supported Barcode Formats......................................................................... 527
Installing Barcode Labels.............................................................................. 528
Appendix A Library Specifications 530
To Next Page
Loading...
Need help?
General
