Chapter 7 Encryption Key Management
Configuring Encryption Key Management on the Library
Scalar i500 User’s Guide 184
Step 5: Running EKM Path Diagnostics 7
Perform EKM Path Diagnostics as described in Using EKM Path
Diagnostics on page 187.
Step 6: Configuring Partitions for Library Managed Encryption
7
Encryption on the Scalar i500 tape library is enabled by partition only.
You cannot select individual tape drives for encryption; you must select
an entire partition to be encrypted.
Configure the partitions as follows:
1 From the Web client, select Setup > Encryption > Partition
Configuration.
The Setup - Encryption Partition Configuration screen appears (see
Figure 27
).
Note: Your screen might look slightly different depending on
which encryption system you are using.
To Next Page
Loading...
