Chapter 12 Installing, Removing, and Replacing
Permanently Removing Expansion Modules From an Existing Library
Scalar i500 User’s Guide 381
6 Close the library’s I/E station and access doors.
7 Connect all power cords, network data cables, and module-to-
module cables. Make sure the module terminators are installed at the
top and bottom of the stack of modules. For cabling instructions, see
Cabling the Library
on page 293.
8 Power on the library.
9 Re-create and/or modify partitions, cleaning slots, and I/E station
slots as desired.
1 Parking tab in “unparked” position
To Next Page
Loading...
