Chapter 12 Installing, Removing, and Replacing
Replacing an Expansion Module
Scalar i500 User’s Guide 407
4 If your library contains FC I/O blades, install both the I/O blades
and the accompanying fan blades in the expansion module. For
details, see Adding, Removing, and Replacing FC I/O Blades
on
page 449 and Adding, Removing, and Replacing the FC I/O Fan
Blade on page 460.
5 Connect all power cords, network data cables, and module-to-
module cables. Make sure the module terminators are installed at the
top and bottom of the stack of modules. For cabling instructions, see
Cabling the Library
on page 293.
6 Power on the library.
7 Re-create partitions, cleaning slots, and I/E station slots as desired.
8 Import tape cartridges to the correct partitions as needed.
9 Save the library configuration (see Saving the Library Configuration
on page 495.
10 If the host application inventories the location of each tape cartridge
in the library, open the host application and reinventory in order to
sync its logical inventory with the physical inventory of the library.
To Next Page
Loading...
