Sencore DMG 3200 - Editing the PSI Default Values

DMG 3200/3100/3000 – User Manual
Page 171 (306)
PSI domain. The system will also automatically create a default network within a newly defined
domain with network ID 65280.
7.6.2 Editing the PSI Default Values
The PSI Default Values tab displays the default playout mode and interval for each PSI/SI table
Figure 7.61- PSI Base Values tab (DVB Profile)
The following fields are available:
Table Id
For reference only, not configurable
Table Type
For reference only
Mode
Select one of the three or four available modes, depending on the
table:
Stop – playout is disabled
Pass – the table PID will be forwarded from the input, without
any modification. This means that tables sharing a common PID
(e.g. SDT A and SDT O, EIT PF A and EIT PF O, as well as TDT
and TOT) must have common Pass settings to avoid a PID clash
with regenerated tables from the playout carousel. In addition,
Pass is not supported for PMT, MGT, TVCT, and CVCT.
Play – the table will be enabled for playout
PSIG – the table will be generated externally via a PSIG server
Playout Interval
Interval in ms between transmissions of each section of the table by