Sencore DMG 3200 - Changing the Language Descriptor of an Incoming Audio

DMG 3200/3100/3000 – User Manual
Page 53 (306)
Figure 5.12– Defining Manual PSI
Figure 5.13– Defining component for service
Component PID
Enter the PID value of the incoming PID to which the signaling shall
be defined.
Component Type
Specify the type of component.
Descriptor Type
Depending on the type of components different descriptor options will
emerge.
5.3.4 Changing the language descriptor of an incoming audio
Figure 5.14 – Edit Language descriptor
PID
The input PID to update.
Type
The audio type where the language descriptor shall be replaced.
• Any
• mpeg-audio
• ac-3
• aac_latm