Sencore DMG 3200 - Manual Switching; EMMG Redundancy

DMG 3200/3100/3000 – User Manual
Page 286 (306)
Figure 10.35 - Setting up ECMG redundancy
The following information is displayed:
IP
Backup ECMG’s IP address
Port
Backup ECMG’s TCP port
Channel
SimulCrypt channel ID for the Backup ECMG
CAS Sub Id
CA vendor specific Sub ID
10.6.3 Manual Switching
Based on Figure 12.8, click Switch. The State value (Running, Sleeping) should change
accordingly.
10.6.4 EMMG Redundancy
When defining the EMMG, it is possible to state its IP address, otherwise known as IP Filter.
Specifying an IP filter prevents unknown EMMGs from connecting to the Scrambler module.