DMG 3200/3100/3000 – User Manual
Page 266 (306)
10.3.2.1 Global Settings
The global settings are available on the Redundancy->Output page in the GUI and are
configured per output module.
Figure 10.14 - Edit Redundancy Options
Enable OSPF
Enables OSPF routing – checking this box allows the following
parameters to be configured: OSPF Area, MD5 OSPF
Authentication, and Stubby Area.
OSPF is used to update the routing tables in the routers. The
redundancy scheme currently does not support any other
routing protocols.
Provided PIM is not controlled by the Sencore equipment, it is
possible to support multiple OSPF neighbours.
This feature requires the output redundancy license.
OSPF Area
Designated OSPF area
MD5 OSPF
Authentication
Check to enable MD5 OSPF authentication. Following are the
parameters necessary to configure this feature:
• Key Id – secret keyword version
• Key – secret keyword
It is possible to have two sets of MD5 keys – the second set is
required to change the key in switch modules.
Stubby Area
Enable this option if the output is connected to a stubby
network
OSPF Metric
Defines the cost of this route in the network
To Next Page
Loading...