Sencore DMG 3200 - Inserting DVP STP

DMG 3200/3100/3000 – User Manual
Page 179 (306)
Generic Descriptor Loop Placement Instructions
Table Loop Name Loop Description Placement Instructions
CAT
- Only one loop
Specify explicit Net ID and TS ID
PMT
program_info Descriptors for all
elementary_streams
Specify explicit Net ID, TS ID, and
Service ID
Select “None” from Component
ES_info Descriptors for current
elementary_stream
block
Specify explicit Net ID, TS ID, and
Service ID
Specify the PID of the elementary stream
from Component
NIT
network Descriptors for entire
network
Specify an explicit Net ID and TS ID
Select “All” from the TS ID drop down box
transport Descriptors for current
transport_stream
block
Specify explicit Net ID and TS ID
SDT
service Descriptors for current
service block
Specify explicit NET ID and TS ID
TOT
- Only one loop No placement option since TOT is
globally defined for the unit
Generic descriptor play out placement is static and the operator must maintain
play out placement in terms of Net, TS and/or Service ID as well as input PID
updates.
Insertion of a generic descriptor will not overwrite any existing descriptors that
are configured on the output.
7.6.8 Inserting DVP STP
If required, the DVBSTP tab allows selection of which network to generate the DVB STP xml
description file.
A ne DVB STP multicast can be added by entering the initial values and clicking on the Add
button. Once added, this will be automatically enabled on the selected IP output.
If it is required to change this multicast, you can click the edit link in which the following
selection is displayed: