DMG 3200/3100/3000 – User Manual
Page 246 (306)
9.2.2 Setting up EPG
To set up EPG for your output transport stream, select EPG
Setup.
Figure 9.5 - EPG Setup
The following parameters are available for configuration:
Automatic EIT Source Selection
Matching Criteria
Used to determine which component(s) of the triplet (NET ID, TS ID,
and SID) will be used to match EPG information with its service.
Multiple Match Action
Lists the course of action that should be chosen if there is more than
one service available for the matching criteria.
The fewer parameters you match on, the higher the chance is to get multiple
matches
Double Input Buffer
Double input buffering allows for a more intelligent EPG update algorithm. In addition, it also
enables the system to flag warnings if the input is corrupt.
To Next Page
Loading...