DMG 3200/3100/3000 – User Manual
Page 247 (306)
The following parameters are available:
Input Data Completion
Timeout
If the EPG for a particular service is not complete within this
timeout, then the system will play the already received data.
The default value is 60 seconds.
Inter Table Update
Timeout
The EPG data is transmitted in different tables, according to the
time which the data describes. For example: EPG for day one is
transmitted in a different table_id compared to EPG for day six.
This parameter specifies the duration the system should wait
between table_ids before it starts to regenerate the content.
If the parameter’s value is low, it is likely that the system will
regenerate several times during the transfer of EPG covering
many days.
The default value is 300 seconds.
EPG Sync Peer Units
In a system with many units, e.g. in a QAM network, there may be a few units belonging to
the same network. In this system, the outgoing EPG should signal all the services.
To synchronize your units, go to EPG
Setup and list the IP address for each remote
EPG module (not IP address for the MMI) under EPG Sync Peer Units.
Figure 9.6 - EPG Sync Peer Units
The EPG module’s IP address can be configured under the Admin node.
Currently the system only supports synchronization of up to five remote EPG
modules.
To Next Page
Loading...