DMG 3200/3100/3000 ā User Manual
Page 249 (306)
9.3 Adding EPG information to a Transport Stream
Figure 9.8 - Setting up EPG within the Outputs Node
Typically, schedule information is carried only on one transport stream per network. To
enable EPG regeneration, select the outgoing transport stream on which EPG
information will be broadcast using the following steps:
1. Select Outputs from the Navigation Pane
2. Select the particular output module
3. Double click on the output transport stream of your choice
4. Select the EPG tab
5. Check the Add EPG checkbox
6. Finally, set the parameters accordingly
The output transport stream will contain schedule information for all channels within the
same network, grouped according to outgoing Network ID.
EPG can be enabled on more than one transport stream within a network ā all these
streams will then carry full schedule information, if they are available from the source.
The EIT schedule will be merged with the EIT Present/Following and Actual/Other.
To Next Page
Loading...