EasyManua.ls Logo

Sencore DMG 3200 - PSI Generation Setup

Sencore DMG 3200
306 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DMG 3200/3100/3000User Manual
Page 180 (306)
Figure 7.68 - DVBSTP Tab
Enable Enables DVBSTP
Net ID Specify a Net ID
Interface Specify an Interface ( Port )
IP Specify an IP address.
Port Specify a Port.
Source Port Specify a source port
TTL Set the Time-to-Live (TTL/IPv4)
TOS Specifies the Type-of-Service (TOS)
Payout Interval Interval in ms between transmissions of each section of
the table by the play out carousel.
7.6.9 PSI Generation Setup
The Setup tab allows for modification of PSI generation settings like table versioning scheme,
CA descriptor placement, PMT caching, and so on.

Table of Contents