DMG 3200/3100/3000 – User Manual
Page 34 (306)
Figure 4.5 - Admin Properties View
In the Admin Properties view, it is possible to configure the Default Interface, Control Port,
and Data Port. Control ports on all input, output and processing except scrambling, bulk
descrambling and EPG modules do not need to be configured.
Default Interface This parameter allows you to select the Management Port to be
used for managing the Web GUI.
For Switch modules with IP interfaces, the Management Port can
be the Control Port, Data Port, or a VLAN (previously added).
Control Port
IP Address
IP address used solely for management. It cannot be used for
multicast reception as it is not for data input.
Gateway Address
Gateway address of the network used for management
Subnet Mask
Subnet mask
DNS Server
Specify DNS Server for Control port applications (ie NTP)
Data Port
IP Address
IP address used for multicast reception
Gateway
Address
Gateway address of the network used to access external resources
Subnet Mask
Subnet mask
Auto Negotiation
Enabled or disabled
Link Speed
Choose from:
• Max
• 100
• 1000
Current Link
Speed
Current detected link speed of the Ethernet interface
Enable ICMP
By default all ports on the Dataport are closed (ie firewall). Enabling this
option enables the port for ‘ping’ to be open. See further details in 4.1.4.
To Next Page
Loading...