Siemens HiPath 1120 - Interdigit Pause Time Setting

General settings
101
Step by step
Required: Programming mode must be activated (*95
31994).
ejm w Enter the programming code.
de ... mm w Enter the length of time (01 to 99 seconds) for external
monitoring. The default setting is 10 seconds.
w Initial status for programming mode.
Interdigit pause time setting
This allows you to configure a pause ("P") between MF
digits. This can be used when programming system and
individual speed dialing, system telephone programma-
ble keys or for enabling Suffix dialing.
This period of time can be set from 1 to 5 seconds. The
default setting is 2 seconds.
Required: Programming mode must be activated (*95
31994).
ffk w Enter the programming code.
e.iw Enter the length of time for the Pause (from 1 to 5 sec-
onds)/
w Initial status for programming mode.