Programming mode
19
Step by step
Canceling a Setting’s Configuration
• You can cancel the configuration of a setting at any
time by pressing the "#" key. The program will then
revert back to the initial screen of the programming
mode.
Exiting a setting’s configuration
There are three different ways to finalize the configura-
tion of a setting. After configuring the setting, you will
be returned to the initial screen of the programming
mode.
• After parameters are entered, the equipment auto-
matically exits programming mode.
• After configuring a setting, press the # key.
• After configuring a setting, wait approximately 5
seconds.
If no code or setting is entered, the system will continue
to wait for an entry or will assume that a "null entry" oc-
curred. It will proceed to the next programming step,
depending on the code first entered.
Exiting programming mode
After completing the configuration of a setting, you will
be returned to the initial screen of the programming
mode. Follow these steps to exit the programming
mode:
t Replace the handset.
To Next Page
Loading...
