Important settings
23
Step by step
Dialing mode on an analog trunk
This features specifies the dialing mode to be used over
an analog trunk (DP or MF).
Required: Programming mode must be activated (*95
31994).
eem w Enter the programming code.
p w Enter a number for an analog trunk (e.g., 801).
e ... f w Enter the appropriate code:
e = Analog line: Pulse (DP)
f = Analog line: Multifrequency tone dialing (MF)
(default
for all analog lines)
p w Enter the next external line number.
or
r w Press this key.
Initial status for programming mode.
Default access to a group of external
lines
This feature configures dialing "0" for each extension as
the dialing method for a group of external lines. The de-
fault external line access code is "0."
Required: Programming mode must be activated (*95
31994).
ddf w Enter the programming code.
p w Enter the extension number (e.g. 11/101).
p w Enter the number for the group of external lines (e.g., 0,
890, etc).
p w Enter the next extension number.
or
[1] For Bolivia and Paraguay, set "01=Brazil" for country/country group
then "02=Spanish" for language.
[2] For Indonesia set "08=Intern. Spanish" for country/group of coun-
tries. then "03=English" for language.
To Next Page
Loading...
