Siemens HiPath 1120 - Symmetric;Asymmetric Call; No ACK Setup for S0 Line

Digital trunk settings
151
Step by step
Symmetric/Asymmetric Call
This setting configures the system for symmetric or
asymmetric calls.
Check with your local carrier to know which operating
mode should be configured for your system.
Required: Programming mode must be activated (*95
31994).
dkh w Enter the programming code.
de, df, Enter the S
0
module slot on the system
1
.
dg or ee
p
Enter the slot for the S
0
module slot:
dd . de = For the HiPath 1120(The Position of
port 00 is only for the external line - PP or PMP)
dd . dh = For the HiPath 1150;
dd . dh = For the HiPath 1190 (For the second
module, place position 11 and port from 00 ... 04).
q or r w Select the mode of the call:
q = Asymmetric
r = Symmetric (default)
w Initial status for programming mode.
No ACK Setup for S
0 line
Check with your local carrier to find out which operating
mode should be configured for your system.
Required: Programming mode must be activated (*95
31994).
dki w Enter the programming code.
de, df, Enter the S
0
module slot on the system
2
.
dg or ee
p
Enter the slot for the S
0
module port:
[1] Module slots are: HiPath 1120 (02), HiPath 1150 (03) and HiPath
1190 (01 and 11).
[2] Module slots are: HiPath 1120 (02), HiPath 1150 (03) and HiPath
1190 (01 and 11).