Siemens HiPath 1120 - Automatic Update of Date;Time; Callback for External Calls Via ISDN

Step by step
General settings
104
Automatic update of date/time
This setting allows automatic synchronization of the
system’s date and time through the local carrier, during
an external call.
Required: Programming mode must be activated (*95
31994).
dgl w Enter the programming code.
q or r w Activate/Disable synchronization:
q = Activated (default)
r = Deactivated
w Initial status for programming mode.
Callback for external calls via ISDN
By configuring this setting, an external ISDN call can
schedule a Callback for the MSN number called.
Required: Programming mode must be activated (*95
31994).
ffe w Enter the programming code.
q or r w Activate/deactivate callback:
q = Activate callback (default)
r = Disable callback
w Initial status for programming mode.
When you restore the default setting (99), the
date the SW was generated will be displayed.
The time displayed will be 12:00.
The settings that are automatically updated are:
month, day, time and minute. Year is not includ-
ed in the FSK message settings - it is defined as
the software’s manufacturing date and can be
manually adjusted.