Siemens HiPath 1120 - Voice Mail Group; Mailbox Assignment for Auto-Answering Mode; Audio Quality

Step by step
EVM module
176
Voice mail group
This setting specifies the UCD group to be used by the
system.
Required: Programming mode must be activated (*95
31994).
fei w Enter the programming code.
p w Enter the UCD subscriber group number (790 to 799).
or
q w Press this key to delete a specified group.
w Initial status for programming mode.
Mailbox assignment for auto-answer-
ing mode
This setting assigns mailboxes to auto-answering slots.
Required: Programming mode must be activated (*95
31994).
fej w Enter the programming code.
e or f Enter the number of the mailbox you would like to se-
lect.
khme or khmf Enter a greeting port for auto-answering.
r w Press this key.
Initial status for programming mode.
Audio quality
This setting specifies the audio quality for playing back
greetings and messages.
Required: Programming mode must be activated (*95
31994).
ffl w Enter the programming code.
If only one extension is selected as the first at-
tendant, only one voice mail group may be se-
lected as a second MSN attendant, (see HiPath
1100 Manager).