Relay and sensor on the HiPath 1120
183
Step by step
Relay
The relay can be activated via the sensor, assuming that
the sensor is configured. It can be activated manually or
automatically after a specified time. When the relay is
activated, the contacts end. When it is deactivated, the
contacts open.
By default, the relay is set to Switch Mode.
Required: Programming mode must be activated (*95
31994).
eki w Enter the programming code.
e ... i Select the operating mode for the relay:
e = "Switch": The relay can only be turned on from an
extension by entering the proper feature code
(see Miscellaneous functions - Relay in the User
Manual).
f = "Monoflop": The relay is closed for a specified
length of time. Alternatively, the relay can also be
opened before the set time, by entering the prop-
er feature code (see Miscellaneous functions -
Relay in the User Manual).
g = "Invert": The current status of the relay is reversed
when the feature code to activate the Relay is
selected at an extension.
h = "Music on Hold": The relay can be used for
enabling external equipment connected for play-
ing announcements/music.
i = "External signal": For an analog extension, a sec-
ond ring can be activated/deactivated using the
relay.
w Initial status for programming mode.
When playing music from an external music
source, all regulations related to copyrights for
the country in question must be followed.
To Next Page
Loading...
